Hydrogen sulfide measurement by headspace-gas chromatography-mass spectrometry (HS-GC-MS): application to gaseous samples and gas dissolved in muscle.
Fiche du document
2015
- doi: 10.1093/jat/bku114
- issn: 0146-4760
Ce document est lié à :
info:eu-repo/semantics/altIdentifier/doi/10.1093/jat/bku114
Ce document est lié à :
info:eu-repo/semantics/altIdentifier/pmid/25336379
Ce document est lié à :
info:eu-repo/semantics/altIdentifier/eissn/1945-2403
Ce document est lié à :
info:eu-repo/semantics/altIdentifier/urn/urn:nbn:ch:serval-BIB_8DFE013879388
info:eu-repo/semantics/openAccess , Copying allowed only for non-profit organizations , https://serval.unil.ch/disclaimer
Sujets proches
Hydrosulfuric acid Sulfur hydride Sulfhydric acid Hydrogen sulphideCiter ce document
V. Varlet et al., « Hydrogen sulfide measurement by headspace-gas chromatography-mass spectrometry (HS-GC-MS): application to gaseous samples and gas dissolved in muscle. », Serveur académique Lausannois, ID : 10.1093/jat/bku114
Métriques
Partage / Export
Résumé
The aim of our study was to present a new headspace-gas chromatography-mass spectrometry (HS-GC-MS) method applicable to the routine determination of hydrogen sulfide (H(2)S) concentrations in biological and gaseous samples. The primary analytical drawback of the GC/MS methods for H(2)S measurement discussed in the literature was the absence of a specific H(2)S internal standard required to perform quantification. Although a deuterated hydrogen sulfide (D(2)S) standard is currently available, this standard is not often used because this standard is expensive and is only available in the gas phase. As an alternative approach, D(2)S can be generated in situ by reacting deuterated chloride with sodium sulfide; however, this technique can lead to low recovery yield and potential isotopic fractionation. Therefore, N(2)O was chosen for use as an internal standard. This method allows precise measurements of H(2)S concentrations in biological and gaseous samples. Therefore, a full validation using accuracy profile based on the β-expectation tolerance interval is presented. Finally, this method was applied to quantify H(2)S in an actual case of H(2)S fatal intoxication.
