Estimating Flow Using Tracers and Hydraulics in Synthetic Heterogeneous Aquifers

Fiche du document

Date

2009

Type de document
Périmètre
Langue
Identifiants
  • handle:  10670/1.gh7mhi
  • Larocque, Marie; Cook, Peter G.; Haaken, Klaus et Simmons, Craig T. (2009). « Estimating Flow Using Tracers and Hydraulics in Synthetic Heterogeneous Aquifers ». Ground Water, 47(6), pp. 786-796.
Relations

Ce document est lié à :
http://archipel.uqam.ca/8011/

Ce document est lié à :
http://dx.doi.org/10.1111/j.1745-6584.2009.00595.x

Ce document est lié à :
doi:10.1111/j.1745-6584.2009.00595.x

Licence




Citer ce document

Marie Larocque et al., « Estimating Flow Using Tracers and Hydraulics in Synthetic Heterogeneous Aquifers », UQAM Archipel : articles scientifiques, ID : 10670/1.gh7mhi


Métriques


Partage / Export

Résumé 0

Regional ground water flow is most usually estimated using Darcy’s law, with hydraulic conductivities estimated from pumping tests, but can also be estimated using ground water residence times derived from radioactive tracers. The two methods agree reasonably well in relatively homogeneous aquifers but it is not clear which is likely to produce more reliable estimates of ground water flow rates in heterogeneous systems. The aim of this paper is to compare bias and uncertainty of tracer and hydraulic approaches to assess ground water flow in heterogeneous aquifers. Synthetic two-dimensional aquifers with different levels of heterogeneity (correlation lengths, variances) are used to simulate ground water flow, pumping tests, and transport of radioactive tracers. Results show that bias and uncertainty of flow rates increase with the variance of the hydraulic conductivity for both methods. The bias resulting from the nonlinearity of the concentration–time relationship can be reduced by choosing a tracer with a decay rate similar to the mean ground water residence time. The bias on flow rates estimated from pumping tests is reduced when performing long duration tests. The uncertainty on ground water flow is minimized when the sampling volume is large compared to the correlation length. For tracers, the uncertainty is related to the ratio of correlation length to the distance between sampling wells. For pumping tests, it is related to the ratio of correlation length to the pumping test’s radius of influence. In regional systems, it may be easier to minimize this ratio for tracers than for pumping tests.

document thumbnail

Par les mêmes auteurs

Sur les mêmes sujets

Sur les mêmes disciplines

Exporter en